This Reactor is very simple to use.
For AUTO Power Generation:
Step 1: Deploy Panel
Step 2: Enable Pumps
Step 3: Make sure Auto Scram is enabled to your liking*
Step 4: Enable Auto Control
Step 5: When Gen. warning sounds, Enable Generator
Step 6: Grab cables on the side, and plug in to Elec. Ports
Step 7: Enjoy!
For MANUAL Power Generation:
Step 1: Deploy Panel
Step 2: Enable Pumps
Step 3: Toggle Auto Scram to your liking*
Step 4: Lower Rods until boiler temp. is over 110 Degrees
Step 5: Enable Generator
Step 6: Grab cables on the side, and plug in to Elec. Ports
Step 7: Enjoy!
*Auto SCRAM when enabled automatically Scrams reactor at over 400 Degrees*
