Corby 33 racing yacht ASYMETRIC
This is a asymmetric rigged racing yacht with each spinnaker system being made to work similarly to the actual yacht.
-Use infinite electrics
-An alternative to my symmetric version!
-When going in optimal conditions it can hit 20knts+
--General--
->The steering angle is at what point you release the button, the momentum will overcorrect slightly then bring you back to the desired heading. I suggest tapping the button to fine tune.
->Best upwind vmg is just off close hauled
->Use the trim lever to raise the nose, it is very sensitive
->Good luck not falling overboard!!!!
--Main--
-> On the right of the entrance to the gangway, you have the two controls, shrink main and main halyard.
-> To raise the main, push the "main halyard" button and wait till its about halfway up the mast, then deactivate the "Shrink Main" button to tension the sail.
-> To lower hit the "Shrink Main" button and deactivate the "Main Halyard"
->Main Winches are winched from the position they are on the real boat, winching from behind the helm.
--Jib--
->On the left of the entrance to the gangway, you have 3 jib controls. Jib sheet controls are just to the left and right of the gangway.
->The jib begins fully tidied away, the only thing required is to ease the jib sheets to allow the tack to be tided
->Raising the jib - first, deactivate the "tidy" button and sheet the jib in fully to the desired side. Then deactivate the "Shrink Jib" button and finally deactivate the "Detension Halyard".
->Lowering the Jib - press the "Shrink Jib" button, then press tidy jib, let off the jib sheets and finally activate "Detension Halyard".
--Spinnaker--
*Launching*
->Move to the foredeck and activate the tack of the spinnaker
-> move back, sheet in the spinnaker to the desired side fully and activate the spinnaker hoist
->Ease the sheets once its fully hoisted
*Recovering*
->connect the clew retreval to the winch just ahead of the sheet winch if its not on the correct side
->Deactivate the spinnaker hoist
->move forwards and deactivate the tack
