I built this semi-automatic oil drilling and refining system to make oil processing as simple and efficient as possible — with just a few manual steps.
How to use:
Drilling: When drilling, make sure to activate the Slurry Cleaner. The switch is located inside the lift.
Refining: To start the refining process, turn on both the Oil Pump and the Furnace.
If something isn’t working or you have suggestions, feel free to leave a comment — I’ll gladly fix or improve it!
Important Note:
Make sure to set the Physics Detail to HIGH in the General Settings menu. If it's too low, the rotary table might break due to physics instability.
