(technically) a remaster of my old [url=https://steamcommunity.com/sharedfiles/filedetails/?id=2884450521] 7375 [/url]
This is a recreation of a locomotive that originates from the movie "Unstoppable" made in 2010.
[hr]
Instructions
[b] STARTUP [/b]
- In the cab, turn on the breakers located at the back to turn on the electricity
- Then sit down in the engineers seat and you should see a column of buttons (that has horn cut-in, cab lights, etc.) turn them all on excluding the top 2, as heating and air conditioning can be used at your own discretion (air conditioning doesn't work)
- Find "engine run" or "engine stop" and next to it should be "generator field" and "fuel pump", turn both of these on.
- Now hold down "engine run" for 5-6 seconds.
- The engine should now turn on and you can now notch/throttle up.
[b] SHUTDOWN [/b]
There are multiple ways to shutdown the engine of the train.
1. Press the "Engine Stop" button in the cab
2. On the exterior of the train, on top of the fuel tanks (both sides), there are "Emergency Fuel Shut-off" switches. Hold down the switch for roughly 2-4 seconds, after about a minute or so the engine should shutdown after pressing.
3. Turning off all the battery cut-ins will also do the trick too.
(shutdown can be iffy most times, especially with "emergency fuel shut-off" as it takes a very long time for the engine to actually turn off for some reason.)
[b] Multiple Unit (MU) System [/b]
The slave system on this train does not support any other slave systems other than the SARR slave system (LTTCC).
- The LTTCC (Linked Train and Train Car Control Unit) is made by Train Master 23 and is the slave system used by SARR supported locomotives.
- LTTCC functions by requiring a "Lead Unit" button in any locomotive that may control a consist. (railcars do not need the "Lead Unit" button)
- Locomotives and railcars that use LTTCC can be used together in a consist. A cable (atleast for official SARR trains) connection between trains and railcars will allow for brake and throttle control of said railcar/locomotive as long as the "Lead Unit" button is active on a locomotive you are controlling.
- Slave system cables can be found in the SD40-2's Electrical Bay.
[b] Other Functions [/b]
- "Emergency Brake Valve" located towards the front of the cab and the "EOTD Emergency" located on the engineers panel will, once pressed, activate brakes for the train/consist. Only difference being that EOTD is for the entire conist, while the brake valve is for the locomotive only.
- The "Electrical Bay" stores a cable for the slave system, as well as ability to turn off the "Infinite Electricity Override". (not recommended as the train has a horribly efficient battery)
- [b] IF YOU ARE USING THE NORTH SAWYER OVERHAUL (NSO) MOD [/b] the locomotive has been installed with a system that lifts the railings. This is to prevent collisions with the station platforms of NSO.
[hr]
Changelogs
- July 28th, 2025 - Uploaded this workshop creation.
[hr]
Stats
#
Mass
12,248
Cost
$164,318
Fuel Capacity
13,921
Max Speed
83mph/134kph
[hr]
Credits
Creator of the locomotive - [url=https://steamcommunity.com/id/MrThomasTheCat] Mr_ThomasTheCat [/url]
Assisted in creation of the locomotive - [url=https://steamcommunity.com/profiles/76561199093597753] Train Master [/url]
Linked Train and Train Car Control Unit (LTTCC) Microcontroller - [url=https://steamcommunity.com/profiles/76561199093597753] Train Master 23 [/url]
[url=https://steamcommunity.com/sharedfiles/filedetails/?id=2946571730] Infinite Electricity Pump [/url] - [url=https://steamcommunity.com/profiles/76561198100304537] pressF [/url] and [url=https://steamcommunity.com/profiles/76561198362825316] freeman [/url]
[url=https://steamcommunity.com/sharedfiles/filedetails/?id=2872512419] EOS American Locomotive Truck Preset Pack [/url]
