This refinery is capable of refining 176L/s of oil, producing 88L/s of each diesel and jet fuel, using a single diesel furnace. This is faster than you could buy oil at an oil platforms' gantry.
Installation:
- Connect your diesel and jet fuel tanks to the pipes seen in picture 2
- Connect your crude oil tank to the pipes seen in picture 3, using 4 large pumps on individual lines as seen in picture 4. Use Liquid- and Gas relief valves as seen in picture 5. Connect those pumps to the "in pumps" node on the microcontroller at the top of the refinery.
- Connect electricity to the circuit breaker
- Connect a toggle button to the "Start" node on the microcontroller
Operation:
- Use the toggle button to start or stop the refinery.
- On the microcontroller, you can set the refinery to run empty after shutdown (default off).
- There are a liquid meter, barometer and temperature probe you can use for monitoring operation.
Specs:
- Cost: 18620
- Mass: 2990.5 (empty)
Note that the refinery might not reach its maximum performance in cold environments. It is tested to work at >26°C.
